- This topic has 2 replies, 2 voices, and was last updated 15 years ago by
.
-
Posts
-
Putting these clips back on to the motor mount bracket on this tumble dryer was a pain …i did not have a wide enough water pump pliers ..then remembered i had my valve spring compressor that was in the car and it took me less than a min to do …What do you guys use because there is some tension on that dam clip and you would need some big jaws to clamp it down 👿
Re: White Knight Motor Mount Clip
If you are talking about the Whirlpool style clip then all I use is a broad ended screwdriver and a mallet. Put one end into situ and using the screwdriver apply pressure to the other end, then tap the end of the screwdriver with the mallet.
George
Re: White Knight Motor Mount Clip
Allsorts wrote:If you are talking about the Whirlpool style clip then all I use is a broad ended screwdriver and a mallet. Put one end into situ and using the screwdriver apply pressure to the other end, then tap the end of the screwdriver with the mallet.
George Thanks George. i did try that but the clip kept bouncing back up so used above method which was easy but just wondered what others used 😛
- You must be logged in to reply to this topic.