hoover candy foamed in sensor replacement

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hoover candy foamed in sensor replacement

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 4, 2011 at 8:20 pm #62065
    ELDAR59
    Participant

    is the replacement of the foamed in sensor in the fridge compartment a job that’s carried out regularly?
    as i understand, the hole made to access the sensor has to be re foamed. is there an easy or preferred method to do this?

    thanks.

    April 5, 2011 at 5:36 pm #348537
    Cras
    Participant

    Re: hoover candy foamed in sensor replacement

    my prefered method alf is to re insulate using a bit of fibre glass insulation tightly packed in then seal over with a square of plastic then covered over with gas closure tape ,i know that most use canned foam to re insulate but my method allows for easier access should you need to return at a later date ,never had any problems 😀

    April 5, 2011 at 7:45 pm #348538
    ELDAR59
    Participant

    Re: hoover candy foamed in sensor replacement

    thanks for that. i wouldn’t use the expanding foam, i would think it gets messy. instead, i might use some builders insulation, cut to shape.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.