- This topic has 0 replies, 1 voice, and was last updated 15 years ago by
.
-
Posts
-
Hello everyone.
I pulled this machine out of storage and it worked great but then stopped dead with a bowl full of water. Now I get no power on self check. I suspect the display board. I have been told that what kills it is one of 5 things. Including the pump, position switch, harness etc. I am unsure which of these is the most likely culprit or how to check them.
Previous to this the machine had been working well. I had conforma-coated the display board and motor controller board, removed the controller housing’s board support tags that commonly catalyse track corrosion and corrosion inhibited the heat sink. It would be a shame for me to give up on the machine now.I would like to get a GW608 Display board for it but I need to make sure that I am not going to fry that one as well.
Can someone please tell me how to find which ancillary is causing the damage?
Many Thanks
Jason
- You must be logged in to reply to this topic.