Beko WM5100W – error – constant pump/drum rotation

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WM5100W – error – constant pump/drum rotation

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 14, 2011 at 5:45 pm #62239
    neon_3SP_glow
    Participant

    Beko WM5100W

    The machine will not reset, it constantly runs the pump and rotates the drum. I suspect the fault is pressure switch related. Can anyone advise me what this error code refers to, if it is an error code?


    The start/pause, extra rinse and wash LED are all lit.
    The pre-wash LED flashes.

    Many thanks guys.

    April 16, 2011 at 6:28 pm #349338
    garn
    Participant

    Re: Beko WM5100W – error – constant pump/drum rotation

    Hi
    Been out on a couple of these the past month.

    iv had the same symptoms before and after a repair.

    Iv Changed pumps carbons and a simple blockage. the last
    was a start option switch cluster.

    On testing the WM i found myself that it was behaving oddly especially the jobs on the carbons and the start control pad.

    ex. Pumping rinsing on a separate spin.unable to cancel program
    i thought hear we go again 😕

    what iv learnt with the beko the past month is if the appliance has broken down mid cycle .
    after repairing it that it stuck in cycle .
    in these cases just leave it finish it may take a while because it may start a full wash again. have a word with the customer and give a courtesy call back just to check u may find that everything is OK and the cycle has finished.

    Beko carbons totally worn out after three years washing for a family of 3 or 4.

    Garn…
    [size=50]don’t byte the hand off that feeds you try and give something back when possible :wink[/size]:

    April 18, 2011 at 7:04 pm #349339
    neon_3SP_glow
    Participant

    Re: Beko WM5100W – error – constant pump/drum rotation

    hey, thanks for the advice garn 🙂

    As it happens i scrapped an identical machine today. The spider, heating element, belt, bearings all done for, but the module, pressure system and motor are all good!

    For a change, a nice twist of fate!!!

    Going to see the machine again tuesday. I will report my findings!

    April 18, 2011 at 7:30 pm #349340
    garn
    Participant

    Re: Beko WM5100W – error – constant pump/drum rotation

    I will look forward to hearing from you neon 3sp

    April 18, 2011 at 7:44 pm #349341
    Allsorts
    Participant

    Re: Beko WM5100W – error – constant pump/drum rotation

    I replaced a module in a WM5100 a few weeks back for very near the same problem… The machine wouldn’t ramp up into full spin .. On the spin program it would do exactly as you’ve described would not reset, it constantly ran the pump and tumbled the drum.

    A change of the module sorted the problem.

    George

    May 4, 2011 at 11:40 am #349342
    neon_3SP_glow
    Participant

    Re: Beko WM5100W – error – constant pump/drum rotation

    yes, i sent the module to emw. re-fitted and solved.

    Thanks for the help 🙂

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.