ADP 8322

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #62516
    Jiggles
    Participant

    The DW seems to do the pre-rinse part of the selected program but then stops with a light on the RINSE cycle and the ON light flashing 3 times between pauses. Anyone know the problem and cure please?
    I rang the manufacturers service line only to be told that because MFI were finished :boops: they could only deal with warranty issues.
    TIA John

    #350328
    kwatt
    Keymaster

    Re: ADP 8322

    Hi John,

    Sounds like a heating circuit failure is being reported and the most likely suspect is the heating element itself, there appear to be two used on a quick look, this one and this one.

    HTH

    K.

    #350329
    Jiggles
    Participant

    Re: ADP 8322

    Thanks kwatt, I’ll go and check it out and get back to you.
    John

    #350330
    Jiggles
    Participant

    Re: ADP 8322

    Update:-
    Removed the machine from its built in situ. Decided after much umming and arring that the bottom cover would be the best to remove. Bingo, I can see everything; located the water heater and circuit tested, damn, damn, damn and blast. It tested ok. I suppose that I ought to be grateful as the pipe clips look a bu**er to remove and replace.
    Next step circuit test to the heater, see kwatt, I still had confidence in your advice.
    Low and behold, where the wires curve under the door to go up to the top switches, a white wire was broken, as was the plastic sheathing around them mind you.
    Removed door panels, replaced wire, botched plastic sheathing together, replaced door panels after much profanity and replaced machine back in situ after a certain amount of umming and arring (ran out of new swear words)
    Upshot is, everything running A-OK
    Big thanks to kwatt, much appreciated pour yourself a big snifter, you deserve it. :worthy:

    John

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.