Hotpoint BWD129 washer/Dryer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint BWD129 washer/Dryer

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • May 6, 2011 at 3:54 pm #62633
    johnnyhoz
    Participant

    Hi all
    had this one last week lights 1,2&4 flashing with door lock as well.
    error codes says:
    f13 lights 1&2&4, dryer ntc/ fan motor
    the fan motor is turning ok went back today fitted ntc but still same problem

    any ideas please

    John

    May 6, 2011 at 4:37 pm #350739
    washtronics
    Participant

    Re: Hotpoint BWD129 washer/Dryer

    fluff build up on condenser filter, hotpoint modified this filter but still gets blocked, unofficially make holes in mesh filter larger so more air flows through

    May 6, 2011 at 7:19 pm #350740
    johnnyhoz
    Participant

    Re: Hotpoint BWD129 washer/Dryer

    Would this bring the fault up whilst running the washer only?

    May 9, 2011 at 5:23 am #350741
    johnnyhoz
    Participant

    Re: Hotpoint BWD129 washer/Dryer

    Could this machine detect lack of air flow on the dryer even whilst the washer is running?
    The machine starts filling on any wash program then after about 10 seconds stops filling, drains and flashes 1,2,& 4 and door lights, with the dryer selected in injects water for a second the fan starts up and the heater is on, this lasts for about 10 to 15 seconds then it stops and the same error lights flash

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.