diplomat dishwasher

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › diplomat dishwasher

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • May 6, 2011 at 9:46 pm #62636
    jth
    Participant

    please help
    ADP 8902 dishwasher

    stopped working and after a read about the net
    i managed to find it was error E1 total acquastop.
    i took it out in garden and emptied sump.
    flood switch seems fine,
    but now it seems to take in water but pumps it back out the waste right away then shows 3 lights as fault {which cant see error code for}
    ive put bend on waste to see if that was causing it to do this ,but still the same..
    thank you for any advice guys.
    regards john

    May 8, 2011 at 9:55 am #350757
    kwatt
    Keymaster

    Re: diplomat dishwasher

    Hi,

    It’s one of those Chinese machines. :rolls:

    The lights are telling you that it still is detecting an overfill error so there’s still water in it or the float switch is being held in an error state for some reason most probably.

    HTH

    K.

    May 8, 2011 at 2:29 pm #350758
    jth
    Participant

    Re: diplomat dishwasher

    found this on the net and it worked.

    reset by turning the power of then on and pressing the programme button 4 time very quickly before the lights appeard we then press the programme button once waited 20sec switched of waited 20sec switched on then selected programme and it worked.
    doesnt seem to be any leaks so far.
    put on normal wash and wait and see.

    thanks for response m8

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.