- This topic has 3 replies, 3 voices, and was last updated 21 years, 6 months ago by
.
-
Posts
-
I don’t know the model number of my machine, but hope you can help anyway.
It’s a Siemens dishwasher with aquastop, from the IQ series.
2 days ago it flooded. And now when I run any program, it starts draining the machine, for about 4 min. Then the display shows ” F “.
To me it seems like it doesn’t let any water into the machine?
Any ideas how to fix this?
Can the program be reset in any way?I really hope you can help me, otherwise I’ll have to do the dishes by hand!
Best Regards
Niki
Re: Siemens
Niki,
Do please furnish us with the model number, there are hundreds of different machines from Siemens. Only then will we be able to fully advise. 😉
The number on later machines is on the door adjacent the latch mechanism, older machines just to the right of the door latch 🙂
Martin
Re: Siemens
Hi,
I do have the same problem like Niki.
Although I cannot find the model no of the Siemens DIshwasherIt does not have any labels on the right hand side
It has a front control panel with
one button on off on the left —-
4 buttons on the right with 4 icons on top 65 55 55 and one other I cannot identifyIt also has another image in between the two sets of buttons with 3 images which I cannot recognise.
I have the same problem, it flooded a couple of days ago and when I use it now it drains the water and then goes on F I have cleaned the filters.
HELP !!
Re: Siemens
cicru wrote:HELP !!
Try this….
FIRST TURN OFF THE POWER, then tip your machine backwards about 45 degrees to check to see if the base is flooded? (have a towel handy to mop up in case!).
Stand it upright, switch on and start the m/c, after a few seconds stop the machine and carry out the ‘reset’ procedure and let it turn off by itself (after 60 secs usually).
It should now work OK after that, if not? then try our repairs@ service to get an expert in!
- You must be logged in to reply to this topic.