Zanussi fle1416 no lights/ start

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi fle1416 no lights/ start

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • August 1, 2011 at 9:54 pm #64266
    colly
    Participant

    Hi guys
    i have been to a zanussi fle1416w today.
    pnc is 91451453800

    The fault is as follows no door locking or led either

    No programme leds are displayed

    After about 15 secs machine starts to beep until machine is turned off no leds are displayed still.

    if you go into test modes leds do light up no fault in memory and if you try to go through test sequence nothing works valves pump motor etc then back to the nasty beeping

    Any ideas ?????

    colly

    August 2, 2011 at 4:39 am #356570
    gandh1
    Participant

    Re: Zanussi fle1416 no lights/ start

    its zanussi, if nothing in diagnostics doesnt work, and theres no error codes its 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} main module. ensure you make a note of the wiring connections. i think i stripped a fle1416 a few months back that was a bearing failure.

    which reminds me, check the bearings arent on their way out, as thatll make it BER

    August 2, 2011 at 5:27 am #356571
    colly
    Participant

    Re: Zanussi fle1416 no lights/ start

    Hi gandh1
    Thank you for your reply
    Bearings are good !!
    I did have a board of another zanuss,not correct one, but same style and working.
    It came of a bearing failure machine also.

    Put it on machine and the same thing seemed to be happening other than when machine first switched on lights on fascia did light up for a few secs it then reverted to original fault.
    colly

    August 10, 2011 at 7:42 pm #356572
    gandh1
    Participant

    Re: Zanussi fle1416 no lights/ start

    its unlikely to mean anything, if the board wasnt correct or you dropped a wire etc. PUT the old pcb back, double and triple check wiring connections and nip them up just to make sure then access diagnostics and let us know how you get on. instructions are available on connects mediator.

    August 11, 2011 at 11:09 pm #356573
    gandh1
    Participant

    Re: Zanussi fle1416 no lights/ start

    lol, chilling out tonight, and its just hit me, you need to put old pcb back in and swap out the wash element. did one today on a zwf1211… didnt give any error codes, like they normally would, but this had obviously been struck by something and where it was pitted rust had formed, and im guessing lowering the insulation resistance…

    August 12, 2011 at 7:08 am #356574
    colly
    Participant

    Re: Zanussi fle1416 no lights/ start

    will give it a go

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.