- This topic has 4 replies, 2 voices, and was last updated 14 years, 7 months ago by
.
-
Posts
-
does anyone have a supplier of components for control modules , transformers , cap’s , relays etc i know maplins and farnell do em but their knowledge of boards aint great . i’m specificly looking for a transformer for a hotpoint aquarius wma 50p model, the fascia mounted board i dont have any value’s on current output but maybe someone out there in ukwhitegoodsland has cheers
Re: electrnic components for pcb control modules
to my knowlege the wma50 board uses a switch mode power supply ( the tranformer is not connected to the mains)
complete board part no C00202268therefore if the transformer has gone it will have taken other components with it ie driver ic TNY254G
take parts off another board the whole range uses same power supply if you want one will take one off an old board and post it to you but as i said just the transformer will do you no good and if it has gone with a bang it may have taken out main control chips
DaveRe: electrnic components for pcb control modules
cheers dave , it went with a bang alright , water drops on the motor sent current back the way it came i think , blew about 3 inches of track also is there any way of knowing if the ic’s are gone ?
Re: electrnic components for pcb control modules
short answer is no until you get power back to the board and see what happens
the only way you could do it is power it from an external source
find a dc power supply 12 to 15 volts
remove transformer so things cant short out
connect wires to C8 capacitor on board
connect external power supply you these wires makes sure +ve and -ve are the correct way round
try board on bench first if you get lights replace board in machine and see if it works
apart from that you could send board to emw they should have a board they can supply without exchange but you will have to askDave
- You must be logged in to reply to this topic.