miele dishwasher g1470 scv1

Re: miele dishwasher g1470 scv1

” F13 – the program is interrupted and the drain pump is operated. The display shows the message Water intake fault F13. After approximately 2 to 4 minutes, the buzzer is activated for 2 minutes. This fault is registered when the desired number of pulses, which varies depending on program, has not been detected within a certain given time (maximum 4 minutes). If the selected program starts with a water softener flushing cycle, the fault code register check is carried out earlier. In the event of a fault, the selected program is interrupted after approximately 30 seconds and the fault is indicated.

Cause:
On-site water supply not in order.

Remedy:
The on-site water supply should be checked by a specialist.

Cause:
Water inlet valve defective.

Remedy:
Check the water inlet valve and replace it if necessary.

Cause:
Flow meter B3/4 is providing too few pulses.

Remedy:

1. Check WPS valve Y2 (filter, restrictor disc).
2. Remove the left side panel.
3. Check that the plate with the reed switch on flow meter B3/4 is seated correctly.
4. Check that the reed switch connection plug is seated correctly.
5. Replace the reed switch, if necessary.
6. Check the control lead from the electronic to flow meter B3/4.
7. Replace the water inlet mixer, if necessary.

Cause:
Water flow pressure at on-site water supply is less than 14.5 pounds per square inch (1 bar).

Remedy:

1. Check the water intake.
2. If voltage is present at the electronic for the solenoid valve, check the solenoid valve Y2 leads for continuity.
3. Check the filter at WPS valve Y2.

Cause:
Filter in WPS clogged.

Remedy:

1. Disconnect the machine from the power supply.
2. Close the on-site water supply.
3. Unscrew the WPS from the on-site water supply.
4. Remove the washer from the threaded union.
5. Remove the filter with needlenose pliers.
6. Clean or replace the filter as necessary.lockage. “