- This topic has 5 replies, 2 voices, and was last updated 14 years, 7 months ago by
.
-
Posts
-
need help with this one, as never come across it before on a smeg.
no blockages in filter, spinner arms removed. clean water supply in, no aquastop on fill. waste disconnected and put in bucket.
it will drain water happily if manually put inside, and then it reverts to constant drain, with bursts of filling / pause / filling… etc.
theres no sign of error codes on fascia panel and its dry as a bone in the base.
was wondering if some of these have a jug impellor?
Re: smeg 10054 format dishwashers – fills and drains simulta
if it helps model is df612sdx and serial is 6103006980 cheers
Re: smeg 10054 format dishwashers – fills and drains simulta
eastlmark? anyone smeggy? dont really want to write it off, customer is the impatient sort who cant live without one for more than a few days… and hubby is the sort to bring a new pile of t@ss home in back of his discovery… probably upside down… because it means hell get fed again
Re: smeg 10054 format dishwashers – fills and drains simulta
as ever with smeg, check all the things you can for earth leaks, however small and suspect the pcb if nothing found. Probably will have an impellor jug thing built into the air break, may or may not be connected….would expect an error code if it were faulty though.
what is all this “format 10054” stuff about?Re: smeg 10054 format dishwashers – fills and drains simulta
i could only remember the type no. of the dishwasher as i couldnt find my notepad with the serial and model in it…! nothing serious 😛 was assuming the 10054 no. refers to the general layout of that format of smeg d/w
Re: smeg 10054 format dishwashers – fills and drains simulta
right finally got this beast in the workshop as cust is never home and upon whipping off the base, and checking everything it all seems to check out ok.
except the underside salt tank solenoid is covered in salt residue, and giving no reading at all. whats the set up for overfilling with these tanks, i.e if that solenoids dead, will there be an overfill sensor/floodtrip inside the tank that cuts in? also would i be right in assuming this valve is only supplied as part of whole dispenser…?
- You must be logged in to reply to this topic.