Gorenje WA72145

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Gorenje WA72145

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 3, 2011 at 5:17 pm #64834
    robbo1973
    Participant

    Hi all going here on tuesday and have never worked on one so advice appreciated,cust saying it is showing F4 fault code?
    Anybody had this before?

    cheers chris

    September 3, 2011 at 5:25 pm #358236
    admin
    Keymaster

    Re: Gorenje WA72145

    If the washing program is active and the motor control unit gets no signal from the tacho generator, the first time the failure occurs a pause of 1minute is executed. This repeats 30 times. If once happen that motor work O.K. than all previous failure must be deleted. When the failure is detected the 31 time’s the washing program is stopped immediately. If the temperature is higher that 60°C than cool down with cold water 30 seconds. Then pumping water 2 minutes. STOP the program. The failure will be displayed.

    Bryan

    September 3, 2011 at 5:35 pm #358237
    robbo1973
    Participant

    Re: Gorenje WA72145

    cheers will check tacho,are they prone to falling off?

    September 5, 2011 at 6:36 pm #358238
    robbo1973
    Participant

    Re: Gorenje WA72145

    carbons just to update

    chris

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.