- This topic has 0 replies, 1 voice, and was last updated 14 years, 7 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hi Hope some one can help?
The above machine runs for 20 minutes and then starts bleeping on all programs exept the fast program. from reading up the machine is not heating the water.
I have checked the NTC and the reading in ohms fluctuates with temperature so that’s ok
The element checks out at I think around 27 ohms
I then checked the Safety switch (Part No 41020658) next to the element and found it open circuit is this meant to be open or closed? If so how do I remove it to replace?
Perhaps I’m barking up the wrong tree. any help would be most appreciated.
Jonathan
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.