hotpoint wml 520

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wml 520

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 7, 2011 at 4:59 pm #64919
    funbobby
    Participant

    went to machine today and normally it clicks when you start or pause it but doing neither of these and refusing to do any programme, even the manual release didnt want to know on occasions? thinking board, had a few of these now and seem so nasty.

    September 7, 2011 at 5:20 pm #358468
    iadom
    Moderator

    Re: hotpoint wml 520

    A lot of the problems like this are linked to dodgy motor connections, they are dreadfully flimsy, I replace the motor plug whenever I get similar faults before sending the PCB to EMW.

    Jim.

    September 7, 2011 at 7:03 pm #358469
    funbobby
    Participant

    Re: hotpoint wml 520

    oh really thats interesting did have a good look around but didnt notice anything obvious.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.