- This topic has 3 replies, 3 voices, and was last updated 14 years, 7 months ago by
.
-
Posts
-
had a cust bring an element off a bosch dw in today, wanting a new one – not heating, after checking it out (wasnt faulty) and having chat bout other issues, get a call this afternoon “actually mate can you pop by i think you better have a look at it afterall” anyway as expected its a dry joint but sticky problem is the wiring back up – lot of loose tags. before i finish reassembling and switch on, just wanted a second opinion on where the wires should go in case ive done anything silly. bit brain drained and dont have a workshop repair to cast my eye over for reassurance.
cheers
rich
This is where ive got it atm
Re: bosch sgs55c02gb element wiring
anyone able to urgently help me or give me a wiring diagram?
i said id give him a call when i found out, but iv had the guy ringing the mobile in last 30 mins wanting me back tonight if i can cos hes throwing a birthday party tomorrow for their kiddy winks and needs it fixed before then ❗ :rolls:
Re: bosch sgs55c02gb element wiring
Sorry for delay in replying. Not sure of the colour coding on your model but basically the heaters are wired as follows: –
The live supply from the module goes to the bottom microswitch tag.(Grey and Black double in your drawing)
The top microswitch link to the right hand heater terminal (short link wire).(Purple in your drawing)
The left heater terminal goes to the thermostat on top of the heater box.(Blue in your drawing)
HTH? 😀
- You must be logged in to reply to this topic.