Bosch SGS5342 GB/17 will not fill with water.

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch SGS5342 GB/17 will not fill with water.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 11, 2011 at 12:53 pm #64975
    Degsey
    Participant

    Hi I have just had the control board repaired by Q.E.R after the heater relay blew one of its pins. The board was returned yesterday and I fitted it.
    The machine will now not fill with water (it did before) and the display just stays at 2H and does nothing.
    If I fill manually and pull the blue bar behind the LHS panel it starts and empties the water after a while but then does not fill with water again or finish the wash. It does heat the water by the way so the heater relay must be working now.
    I have cleaned the matrix out of crud and also the pressure chamber and the hose that comes out of it. When the red lever is lifted it will empty the machine.
    I have removed the water hose and checked for any blockages and all of the filters have been cleaned. I don’t know what to look at next.
    Many thanks for any help in advance.

    September 12, 2011 at 1:28 pm #358713
    electrofix
    Moderator

    Re: Bosch SGS5342 GB/17 will not fill with water.

    have you checked

    1 you have water turned on and no kiks in pipe
    2 solenoid water valve coil failure normally in a quiet room as it tries to fill you will hear a faint buzz from the valve. if no buzz dont assume its not getting power chack coil first but if no power coming from board look first for broken wires in the door


    Dave

    September 12, 2011 at 5:32 pm #358714
    Washman
    Participant

    Re: Bosch SGS5342 GB/17 will not fill with water.

    Hi

    2H means that you have the time delay set,just cancel delay time.

    2H = 2 hour delay before machine will start.

    Washman

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.