Zanussi ZWD16581W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWD16581W

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • September 12, 2011 at 2:30 pm #64992
    robbra
    Participant

    PNC 91460430200
    This will start and wash sporadically.
    Most times the start button flashes, the door locks, takes 4 seconds of water then stops, door unlocks and start button flashes.
    Other times door won’t lock at all. No sequence flashing and no other codes.
    Any help welcome.
    Thanks
    Rob

    September 12, 2011 at 3:06 pm #358748
    electrofix
    Moderator

    Re: Zanussi ZWD16581W

    check your email from your website sent you some reading material

    Dave

    September 12, 2011 at 3:21 pm #358749
    robbra
    Participant

    Re: Zanussi ZWD16581W

    Thanks Dave,
    I just can’t get my TDS to load after my laptop crashed so the info is very welcome.
    Thanks again.
    Rob

    September 12, 2011 at 4:40 pm #358750
    electrofix
    Moderator

    Re: Zanussi ZWD16581W

    any time m8

    got my tds running on a virtual cd using virtual cd v9
    that means its loaded onto my hard drive as an iso file
    also means i can install same disk on 3 computers with 1 disk.
    using hard drive is faster access than cd and you cany scratch the cd

    Dave

    September 13, 2011 at 7:42 am #358751
    Martin
    Participant

    Re: Zanussi ZWD16581W

    robbra wrote:Any help welcome.

    Dryer element has an earth leak I expect.

    September 22, 2011 at 6:36 am #358752
    robbra
    Participant

    Re: Zanussi ZWD16581W

    Martin, you were partly right. Also a wire broken away from the NTC in the condenser but the heater board u/s too.
    Thanks Dave and Martin.
    PS. Got the TDS to load so a bit happier now.
    Rob

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.