Smeg DWI614 F8

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Smeg DWI614 F8

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • September 22, 2011 at 6:25 am #65213
    robbra
    Participant

    I know this is the diverter valve but the fault is the word of the customer. I couldn’t verify it.
    Trying to do the test sequence I got to F1 but it wouldn’t start the test.
    Could it be the cycling pump at fault also as in the test procedure?
    Thanks
    Rob

    September 22, 2011 at 7:32 am #359702
    eastlmark
    Moderator

    Re: Smeg DWI614 F8

    what happens if you just start a wash program? I personally never bother with the test prog, set a glass wash, close the flap and start up.
    checked for water in the base? look for slight leak evidence under the diverter valve, only takes a drop of water on the switch in the valve to cause all sorts of issues.

    September 22, 2011 at 3:48 pm #359703
    robbra
    Participant

    Re: Smeg DWI614 F8

    Hi Mark, can’t start a programme as it is now stuck on F1. Tried shutting door with it on and off, holding the prog button, everything I can think of but no change. This is the first Smeg since the old Servis dishwashers were made by them so no previous.
    Will check for a water leak.
    Rob

    September 22, 2011 at 5:24 pm #359704
    eastlmark
    Moderator

    Re: Smeg DWI614 F8

    check carefully for an earth leak however small, unplug the circ pump motor, see if that frees off the pcb. dito the alt valve. As she reported a E8 first then I would suspect that.

    September 23, 2011 at 6:27 am #359705
    robbra
    Participant

    Re: Smeg DWI614 F8

    Thanks for the tip Mark.
    Going back today.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.