Beko DRCS68W broken belt

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko DRCS68W broken belt

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • September 30, 2011 at 7:14 am #65374
    allan73
    Participant

    Am I correct in thinking there is an issue with front bearing housings on some Beko cond dryers?
    If so could anyone please tell me if this model could be affected ?

    Allan.

    September 30, 2011 at 6:30 pm #360270
    BobHope
    Participant

    Re: Beko DRCS68W broken belt

    that model my be affected, but it depends on the s/number. PM me your email address and i will send some info.

    Bob.

    EMAIL sent.

    October 4, 2011 at 6:11 pm #360271
    b
    Participant

    Re: Beko DRCS68W broken belt

    Nightmare job to fit a Belt on this model !

    Good luck

    Barry

    October 4, 2011 at 6:17 pm #360272
    BobHope
    Participant

    Re: Beko DRCS68W broken belt

    the belt can be fitted in 15 mins, the mod to stop it snapping again is a full rebuild and very expensive if its out of warranty.

    Bob.

    October 5, 2011 at 10:37 am #360273
    allan73
    Participant

    Re: Beko DRCS68W broken belt

    Luckly new drum in this one, so didn’t require modification 8)
    Found the job a little tricky as it’s my first beko cond belt but I’m sure i could get quicker on them.

    thanks for the input.
    Allan.

    October 5, 2011 at 3:17 pm #360274
    BobHope
    Participant

    Re: Beko DRCS68W broken belt

    dont know which way you done it Allan but heres my way, 3 screws out of top, remove top, remove all the back screws but not the heater cover screws, remove the pump hoses from the top, pull the back compleate with the drum out just enough to release the heater and thermistor plugs, slip the belt on over the front of tub, and reverse, job done.

    Bob.

    March 21, 2012 at 12:26 pm #360275
    neilsukwg
    Participant

    Re: Beko DRCS68W broken belt

    Got same machine and belt has snapped after fitting new one 2 weeks ago. This time going back with front bearing felt as well.

    Serial No. 09204584-10

    What method should be used to stretch belt over motor pulley?

    I levered down with a screwdriver under motor bracket last time. I presume there must be a better way?

    Neil

    March 21, 2012 at 12:37 pm #360276
    bazza500
    Participant

    Re: Beko DRCS68W broken belt

    I use a 13mm socket on an extension bar and ratchet handle. Out socket over pulley, force ratchet handle down and turn and the belt slips on.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.