Hoover HC6 150M – sticking during the rinse cycle

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HC6 150M – sticking during the rinse cycle

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • October 11, 2011 at 1:48 pm #65579
    nelson
    Participant

    I’ve been out to this one today, customer had complained of machine taking upto 8 hours to complete a 40degC wash cycle.
    After testing the pump, fill valves, heater and motor (brushes) and everything was in order. I put the machine on a wash, it did everything ok until it got to the drain/spin before the final rinse, where it drained out all the water, then distributed for a while, then began to spin but just as it stepped upto the high speed spin the machine cut out and returned to the start of that part of the cycle it continued to do this an other three times before I had had enough and switched it off.
    I am reckoning on it needing a new module, but A. would like your thoughts first. And B. not sure where to source one, not listed with Qualtex, Masterpart or Connect.

    All help appreciated.

    Cheers

    October 11, 2011 at 4:02 pm #361062
    Martin
    Participant

    Re: Hoover HC6 150M – sticking during the rinse cycle

    Selector switch or earth leak on heater….? If module fault the likes of Connect would stock them. Not stocked usually indicates no demand. 😉

    October 11, 2011 at 4:15 pm #361063
    don
    Moderator

    Re: Hoover HC6 150M – sticking during the rinse cycle

    Module is 97922801. Out of stock at Connect and not a normal stock line by the looks of it. Martin could be onto a winner with his diagnosis 😉

    Don

    October 19, 2011 at 9:23 pm #361064
    nelson
    Participant

    Re: Hoover HC6 150M – sticking during the rinse cycle

    Thanks Martin & Don, I changed the selector switch and it worked a treat.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.