Bosch SGI43E02GB/08

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch SGI43E02GB/08

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 27, 2011 at 3:54 pm #65913
    Criscold
    Participant

    Been to a semi integrated Bosch SGI43E02GB/08 Dishwasher to sort out a leak that was dripping from under the door. Nice simple job I thought either Lower arm or Seal. Had to remove the outer door and found that the Front edge of the lower tank had warped in the middle and then whilst washing the water was lapping over the centre of the front edge. Just wondering if anyone else has seen this fault and know if there is a cure or modification other than replacing the machine

    October 27, 2011 at 9:00 pm #362366
    leavemetogetonwithit
    Participant

    Re: Bosch SGI43E02GB/08

    Is it maybe squeezed a bit tight in between the units? Although if so I would have thought the door wouldn’t close properly.
    Mike.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.