Bosch washer progs too long

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch washer progs too long

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 30, 2011 at 9:11 am #65951
    mike100
    Participant

    WAE24165gb/04. Progs on cottons side started to take much longer to complete. she has to stop and change to rinse cycle to complete.Now it is the easycare side doing the same.
    Water goes in/ out ok. Heater ok.
    Mike

    October 30, 2011 at 9:18 am #362480
    Martin
    Participant

    Re: Bosch washer progs too long

    Most likely a heat related problem, so either the heater is faulty or there’s no supply getting to it (i.e faulty module/heater relay contact) 😉

    November 2, 2011 at 6:58 am #362481
    mike100
    Participant

    Re: Bosch washer progs too long

    is that a replaceable part or is it a new module.
    Mike

    November 2, 2011 at 9:02 am #362482
    Martin
    Participant

    Re: Bosch washer progs too long

    mike100 wrote:is that a replaceable part or is it a new module.

    Sometimes you can get away with resoldering the dry joint on the heater relay. First job is to establish if your getting 240v to the heater terminals. If not, the next step is to remove the module and inspect it to see if its just a dry joint around that all important relay. 🙂

    November 3, 2011 at 12:46 am #362483
    leavemetogetonwithit
    Participant

    Re: Bosch washer progs too long

    Mike100, Go and read simple pcb repairs sticky three times through. :lesson:
    Mike.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.