Hotpoint Wf000 – All lights flashing

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint Wf000 – All lights flashing

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • November 2, 2011 at 2:29 pm #66019
    nelson
    Participant

    I have been to this one today, all LEDs flashing fast, I have come across this fault quite a few times and usually replacing the 10v 680uf capacitor on the PCB does the trick but not today 😥

    When I refitted the board I still had the same fault, are there any other components that can cause this fault?

    The capacitor that I replaced did appear to be slightly domed so I am a bit puzzled.

    I am going to replace the replacement capacitor just in case it is a dud.

    Thanks for any help.

    November 2, 2011 at 3:34 pm #362754
    iadom
    Moderator

    Re: Hotpoint Wf000 – All lights flashing

    Have done loads of these, only had one with a domed cap that was still the same after fitting a new one.

    Customer couldn’t afford to pay me to take it further. 🙁

    November 2, 2011 at 4:07 pm #362755
    nelson
    Participant

    Re: Hotpoint Wf000 – All lights flashing

    Cheers Jim, I’m going to try an other capacitor in and if it doesn’t work, it’ll be a phone call to EMW.

    November 3, 2011 at 7:04 pm #362756
    roy1
    Participant

    Re: Hotpoint Wf000 – All lights flashing

    Are the lights flashing at full or half power ,If its half power the problem is the 400v 22uf capacitor on the power supply they go out of range if you test them on an esr meter.
    Roy

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.