Bosch washer WAE2416SGB Flashing Leds

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Bosch washer WAE2416SGB Flashing Leds

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • November 4, 2011 at 7:38 am #66069
    bobnorris
    Participant

    3 leds flashing,1200,800 and rinse hold and wont start.The book says motor fault.Sure enough carbons shot.Fitted carbons and comm was in good order,continuity on all motor circuits.Problem is it still wont start and leds still flashing.I see on your search you have to reset the board,have you got details of this process please? By the way i took the boards out and they dont look damaged,665351 and 449238,and the customer reports the house trip switch did not go at the time.
    Cheers
    Bob

    November 4, 2011 at 8:19 am #362924
    A1engineer
    Participant

    Re: Bosch washer WAE2416SGB Flashing Leds

    – Close the door
    – Set program selector switch to position 0 (“OFF”)
    – Wait two seconds
    – Set program selector switch to position 8 (drain)
    – Wait until the start LED is flashing. (will take about two seconds)

    – Wait two seconds
    – press and hold Reduce spin speed button
    – Set program selector switch to position 9 (wool??)
    – Release the “Spin speed” button.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.