Kingswood/Whirlpool KFID60A Internal Water Feeder Tube Issue

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Kingswood/Whirlpool KFID60A Internal Water Feeder Tube Issue

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 9, 2011 at 3:53 pm #66184
    bryanfinlayson
    Participant

    We have a Kingswood Dishwasher (KFID60A) that intermittently is not cleaning correctly.

    It appears that the feeder tube to the upper spray arms is being forced out of it’s housing in the floor of the tub part of the way through the cycle; that is, when I make sure it is properly connected at the start, after each “bad” wash it has worked it’s way out. I can only assume that the poor wash is because the correct volume/pressure of water is not getting to the upper spray arms as a result if it becoming disconnected.

    Is there anything I can do to prevent this? Is there a clip or something that should be there to hold it in place.

    I have checked and cleaned each of the arms and the filters etc a number of times just in case this was an issue, but to no avail.

    Any help gratefully received.

    Thanks

    Bryan

    November 9, 2011 at 4:17 pm #363401
    kwatt
    Keymaster

    Re: Kingswood/Whirlpool KFID60A Internal Water Feeder Tube I

    No, all you can do is replace the assembly IIRC on those.

    K.

    November 9, 2011 at 4:26 pm #363402
    bryanfinlayson
    Participant

    Re: Kingswood/Whirlpool KFID60A Internal Water Feeder Tube I

    OK – thanks for that; I appreciate the response.

    Cheers

    Bryan

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.