SMEG DWF64.1.55 Not filling.

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › SMEG DWF64.1.55 Not filling.

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • November 12, 2011 at 1:39 pm #66243
    rsjon
    Participant

    My SMEG dishwasher, Type 10030, model DWF64.1.55 is not filling with water. There is no water in the bottom, so the float has not activated the aquastop.
    Is it likely the Aquastop is faulty or is there a common fault that means the machine is cutting the aquastop off?
    Thanks,
    Jon. 🙁

    November 15, 2011 at 9:38 am #363589
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    I have checked the voltage to the aquastop…only 59 volts. I checked the cut off switch and although I found no fault when I reassembled the voltage to the aquastop was 250 volts and the aquastop works.
    The machine now fills with water but does not run.
    Can anybody please advise me on my next steps?
    Jon.

    November 17, 2011 at 9:11 am #363590
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    Will/can nobody help me? 🙁
    Jon

    November 18, 2011 at 10:13 am #363591
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    Why will nobody help me?
    Time to go elsewhere methinks. 😥 😥 😥

    November 22, 2011 at 8:53 am #363592
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    BTT

    December 5, 2011 at 7:35 pm #363593
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    BTT

    December 5, 2011 at 10:13 pm #363594
    stevebunyan
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    Have you checked the wash motor.
    If it is filling then appearing to do nothing this could be the wash motor stuck or capacitor blown.

    December 15, 2011 at 9:13 am #363595
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    Thanks for that; I am going to have a look now. I guess the wash motor is the large motor underneath and the evacuation motor is the smaller one?
    Jon.

    December 15, 2011 at 11:08 am #363596
    rsjon
    Participant

    Re: SMEG DWF64.1.55 Not filling.

    Update: Seal between wash motor and impeller has failed ruining motor and actually detaching impeller from motor shaft.
    Machine is a write….not worth repairing.
    Thanks for the pointers from one (!) person. Hope this helps somebody else.
    Anybody need any bits from this machine?
    Jon. 🙁

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.