Bosch SGS43C02GB/43. Not heating.

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch SGS43C02GB/43. Not heating.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 7, 2011 at 8:23 pm #66736
    jerry111
    Participant

    Hello everyone 😀

    There seems to be a ‘stock’ fault with the control PCB’s on these machines, the problem being that the heater relay runs hot. In the past I’ve actually changed the relay on my own machine for a heavier rated one than was originaly fitted. My wife happened upon a notice on the Bosch consumer site today saying that this and other models are now part of a recall. The website states that ‘there is failure of a single soldered joint’ on the control pcb.

    The original relay is rated at 125vAC 10A. The one I fitted from RS was rated at 250vAC 10A. This has worked perfectly now for some time. It cost £1.03+vat!

    Has anyone had any experience of this?

    Thanks for any advice / comments.

    jerry111 😉

    December 8, 2011 at 7:59 am #365063
    clivejameson
    Participant

    Re: Bosch SGS43C02GB/43. Not heating.

    Yes, there has been a discussion of this as there have been some disastrous failures…if you have a good search on the site there’s plenty to read about.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.