VTDOOP drum

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › VTDOOP drum

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • December 14, 2011 at 8:08 pm #66869
    roy1
    Participant

    I fitted a drum shaft/bearings/seals & belt a few weeks ago,got called back for a vibration noise & found the drum juddering on the front bearings.I fitted another set and it worked fine has anyone had to fit a new drum to stop this promlem returning
    Thanks Roy.

    December 14, 2011 at 8:35 pm #365472
    Criscold
    Participant

    Re: VTDOOP drum

    Was it a genuine kit – I had this problem once with a non genuine kit

    Colin

    December 14, 2011 at 9:31 pm #365473
    jag-12
    Participant

    Re: VTDOOP drum

    Had same problem with pattern front bearings.
    Fitted genuine no problem since

    December 19, 2011 at 8:01 pm #365474
    roy1
    Participant

    Re: VTDOOP drum

    Yes both sets were genuine parts
    Roy.

    December 20, 2011 at 8:39 am #365475
    Martin
    Participant

    Re: VTDOOP drum

    These ru44dy heaps of tin implode due to the stress the elastic band puts on the drum. The whole cabinet groans and distorts especially around the bottom kickstrip panel. The front panel drops forward fractionally making the heater duct twist out of line. Then the drum runs almost like driving a car uphill with the brakes on, something just has to give at that point….. 😐

    December 21, 2011 at 8:11 pm #365476
    roy1
    Participant

    Re: VTDOOP drum

    Nice

    December 21, 2011 at 10:02 pm #365477
    QUICK FIX
    Participant

    Re: VTDOOP drum

    was at one today where you cant change the drum shaft you need a whole drum answer put it in a skip 18 month old

    December 21, 2011 at 10:22 pm #365478
    johnnyj
    Participant

    Re: VTDOOP drum

    If your careful you can prise the riveted shaft off with a screwdiver and fit the screwed shaft done a few now 1st one i tried i punctured the drum.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.