Kenwood KDW24F/1

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Kenwood KDW24F/1

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 19, 2011 at 7:51 pm #66962
    geoff1
    Participant

    Hi

    Looking for the part number for the o ring that fits between the pump housing and sump.
    The kit of o rings I have are either too thin or too thick for this machine 👿

    Geoff

    December 20, 2011 at 12:53 am #365768
    leavemetogetonwithit
    Participant

    Re: Kenwood KDW24F/1

    I bought myself three different thicknesses of nitrile cord from these people after reading somewhere on their site that you just have to cut to length and use superglue to join. Surprisingly, it works well.
    http://www.altecweb.com/home.asp?cat=RangeB05
    I’ve used it to good effect on a couple of occasions but not often needed so I’ve got a lot of surplus. Can send you a foot each of 3mm and 4mm and 6″ of 2mm although Xmas post could hold it up. Failing that you could cut down a larger ring of the right thickness if you have one.
    Mike.

    December 20, 2011 at 11:34 am #365769
    geoff1
    Participant

    Re: Kenwood KDW24F/1

    Hi Mike

    Many thanks for offer and tip for making o rings.

    If it is possible to send me some and I will give it a go.

    Have emailed my address to you

    Many thanks

    Geoff

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.