Replaced heater in machine now it seems to be stopping durin

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Replaced heater in machine now it seems to be stopping durin

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • December 22, 2011 at 10:44 pm #67039
    Bero
    Participant

    Replaced heater in machine now it seems to be stopping during wash. Beko WM5120S, machine was tripping kitchen breaker, was told to replace heater , used generic element now machine not running fully during was, would it be something I did wrong, any help

    December 23, 2011 at 7:03 am #366054
    timdowning
    Participant

    Re: Replaced heater in machine now it seems to be stopping d

    would it be something I did wrong, any help

    Possibly? Wheres my crystal ball 🙂

    Numerous things, did you kink the drain hose or fill hose when you pushed machine back in?

    Did you disturb some wiring somewhere?

    Did you check the pressure system to make sure its not blocked.

    Does a rinse and spin work ok or is it just the wash?

    Remember do unplug the machine if you are going back in!!!

    December 23, 2011 at 10:39 am #366055
    Bero
    Participant

    Re: Replaced heater in machine now it seems to be stopping d

    Hi, the machine fills, but noticed that drum is not going around. It seems to stop and after a while start light flashes. When I then press it, it goes to spin empty’s water but does not spin. I replaced heater put original thermostat in. I did remove cable for motor but that is back i. So I’m still stumped

    December 23, 2011 at 11:09 am #366056
    Martin
    Participant

    Re: Replaced heater in machine now it seems to be stopping d

    Bero wrote:So I’m still stumped

    I would look very very closely at the motor and the connections to it. 😉

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.