Fagor 2FU-3611IT integrated washer – F2

This topic has 4 replies, 3 voices, and was last updated 14 years, 3 months ago by aqualectric.

Viewing 5 posts - 1 through 5 (of 5 total)

Author

Posts
January 5, 2012 at 10:59 pm #67222

aqualectric
Participant

Fagor 2FU-3611IT integrated washer. N. 060321540. COD 905112292.

F2 fault – No drain within 6 minutes. Cleaned sump hose, pressure bottle, fitted new pump, outlet hose and sink trap clear……..did 2 washes and F2 again!!! 👿 F3 would be a motor fault so is it remotely possible that a brush failure can somehow generate a F2 fault?
I am now thinking it must be a board fault unless anyone knows better! First Fagor machine I’ve seen for maybe 18 years.

Thanks,

Steve.

January 6, 2012 at 11:37 pm #366714

aqualectric
Participant

Re: Fagor 2FU-3611IT integrated washer – F2

Any ideas??

Thanks,

Steve.

January 7, 2012 at 12:30 am #366715

kwatt
Keymaster

Re: Fagor 2FU-3611IT integrated washer – F2

This might seem obvious or even a bit daft….

You have checked what detergent is being used haven’t you?

The reason I ask is that, if it over foams you can get suds stuck in the pressure hose holding the level switch open fooling the electronics into thinking its not drained when it actually has. If you see what I mean.

It’s not uncommon for the great unwashed to buy whatever is on special in Tesco this week and not have a clue how to use it.

K.

January 9, 2012 at 10:02 am #366716

ben–nevis
Participant

Re: Fagor 2FU-3611IT integrated washer – F2

Hi Steve,

If you PM your email address I will send you any tech info I have on the machine.

regards

January 11, 2012 at 8:44 pm #366717

aqualectric
Participant

Re: Fagor 2FU-3611IT integrated washer – F2

Thanks for the replies – but as always when I put a lot of time into researching something, they decide to scrap it.
Cheers anyway…..!!

Steve.
Author

Posts

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.