AEG 88830W Update C6 fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG 88830W Update C6 fault

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • January 18, 2012 at 8:32 am #67423
    aroffauz
    Participant

    Hello
    I have an AEG 88830W Update PNC 91400205700 with a C6 fault
    I have replaced the pressure sensor and re seated the contacts on the PCB – still have the fault – it generally appears just a t the start of the rinse – all solenoid coils are same resistance
    – any ideas
    Thanks
    Declan 😀

    January 18, 2012 at 8:46 am #367405
    Criscold
    Participant

    Re: AEG 88830W Update C6 fault

    Pressure Switch,Heater,Wiring, check heater & motor insulation

    Colin

    January 18, 2012 at 8:55 am #367406
    Martin
    Participant

    Re: AEG 88830W Update C6 fault

    Reading from the service manual it also states that the heater can give the same error code. Also to clear an error once rectified the ‘customer test programme’ may have to be undertaken (pre-wash and soak buttons pressed then rotate dial to 2nd position – clockwise – then switch to off), should clear error code hopefully?

    HTH. 😀

    January 18, 2012 at 7:00 pm #367407
    aroffauz
    Participant

    Re: AEG 88830W Update C6 fault

    Hi Criscold and Martin thanks for your help
    Kind Regards
    Declan

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.