- This topic has 0 replies, 1 voice, and was last updated 14 years, 2 months ago by
.
Viewing 1 post (of 1 total)
-
Posts
-
Hello all
I have a 8yo GW712 and just replaced the MCM after I got error code 66. Followed the instructions and after I checked the size setting for 7kg tried to check the operation. It started well and the fill time was about 30 seconds (hardly showing water in the bowl) followed by the pump activating. Just after the pump activated the cold water again started…no agitator. I checked error code and it was 40 – pressure transducer tube seems OK – drive spline in good condition and of course MCM is new…
Any ideas? (from a frustrated Aussie) Thank you!
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.