Hoover OPH714D-80 gets to 1 minute

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover OPH714D-80 gets to 1 minute

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 16, 2012 at 1:43 pm #67943
    Washman
    Participant

    Hi

    As above on any cycle machine will go through complete cycle do the spin at the end, and display shows 1min then after about 2 min machine will go through spin cycle again . It will keep on doing this until machine is switched off. Any ideas.

    Mike

    February 16, 2012 at 1:55 pm #369109
    Martin
    Participant

    Re: Hoover OPH714D-80 gets to 1 minute

    If it’s got a welded tub then my guess is that ruddy intergral air bottle pressure chamber may be worth a butchers. Also megger those flippin’ elements as earth leaks create havoc with the microprocessor.

    February 16, 2012 at 7:03 pm #369110
    loopey
    Participant

    Re: Hoover OPH714D-80 gets to 1 minute

    heater o/c or low insulation as martin said lol quick test is to temporally pull off the earth lead to heater ..

    February 16, 2012 at 7:11 pm #369111
    BobHope
    Participant

    Re: Hoover OPH714D-80 gets to 1 minute

    best to disconnect the live and neutral to the heater as there is still an earth path back throuh the water,inner tub and its earthing wire on the tub bearing housing. 😉

    Bob.

    February 17, 2012 at 10:41 am #369112
    Martin
    Participant

    Re: Hoover OPH714D-80 gets to 1 minute

    …..and disconnecting the heater will then show up an E14 error and the occasional E02 or E08 errors just for good measure. 😯

    February 17, 2012 at 4:46 pm #369113
    BobHope
    Participant

    Re: Hoover OPH714D-80 gets to 1 minute

    Martin this is just for testing and yes you will get an E14 but not the other two, best to check the heater with an insulation tester when hot.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.