SMEG Double Oven SUK62MFX

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › SMEG Double Oven SUK62MFX

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • November 15, 2004 at 8:10 am #6813
    admin
    Keymaster

    Can anyone advise!!

    Just recently when using both ovens at high temeperatures, say 200C the top oven will at a random time during cooking completely shut down including the lamp extinguishing a bit more than just the oven stat I feel. The oven then needs to completely cool before it is usable again. Any idea which temp. sensor is causing this and how easy it it to replace. I havent as yet taken any panels off to look for any obvious signs.

    Regards

    Ray D

    November 15, 2004 at 9:48 am #119760
    kwatt
    Keymaster

    Re: SMEG Double Oven SUK62MFX

    Hi Ray,

    If it were a new installation I’d suspect poor ventilation causing an overheat situation and tripping the safety stat out. Other than that it pretty much has to be a faulty stat, either the oven one allowing the appliance to overheat, or the safety stat which, in this case, is a little PCB.

    Hope that helps.

    K.

    PS. Meant to add, there could be a faulty cooling fan as well that could cause this too.

    November 15, 2004 at 9:57 am #119761
    admin
    Keymaster

    Re: SMEG Double Oven SUK62MFX

    K,

    Thanks for the info. Just to confirm one thing. Is there is a separate safety stat for each oven as the main oven continues to function.

    I will disconnect gas and electricity and have a look tonight

    Regards

    Ray D

    November 15, 2004 at 10:18 am #119762
    kwatt
    Keymaster

    It doesn’t look as if there is, but I’m only looking at a line drawing which ain’t the best it has to be said. The PCB isn’t even listed on the parts list yet is shown in the diagram. 😕

    Welcome to dealing with the Italians! 😉

    K.

    November 15, 2004 at 11:13 am #119763
    admin
    Keymaster

    Re: SMEG Double Oven SUK62MFX

    K,

    I’ll try to make up a diagram and note part no’s when I get the thing in bits!!!


    Ray D

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.