Kenwood Dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Kenwood Dishwasher

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • February 27, 2012 at 11:41 am #68131
    lyndy
    Participant

    Hi there

    Got a Kenwood dishwasher KDW12SL3A – not heating water for wash cycles. Will this just be the element or stats, or does anyone know of any other faults that would cause this? Kenwood dishwashers seem to give us a headache at the moment so want to double check possibilities before visiting.

    Thanks

    February 27, 2012 at 1:31 pm #369959
    A1engineer
    Participant

    Kenwood Dishwasher

    Most likely just the screw in type cutout stat at rear of machine above motor, if not could be Heater/wiring/module, obv you got to hope its the simple one lol

    February 27, 2012 at 6:53 pm #369960
    DPDOM
    Participant

    Re: Kenwood Dishwasher

    Had on with stats gone because circ pump capacitor gone too.

    February 27, 2012 at 7:19 pm #369961
    admin
    Keymaster

    Kenwood Dishwasher

    Hi lyndy

    Try putting an extra 1.5 Ltrs of water into it after it has started the wash. If it works the. It’ll need a modified pressure switch

    Bryan

    March 5, 2012 at 8:39 am #369962
    snig
    Participant

    Re: Kenwood Dishwasher

    Just done one of these last week. Module fault on mine, module was about £70. EMW may repair heating faults for less !

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.