- This topic has 2 replies, 2 voices, and was last updated 14 years, 1 month ago by
.
-
Posts
-
Hi..hope someone can help..the machine keeps coming up with the fault c6..the element/motor brushes are ok and it haa just had both pressure switched replaced…the sump hose has been cleared…the only thing i can think of is the pcb..as this is very expensive and there are 2 of them i was hoping someone could tell me if this would fix the problem? i have checked for loose cables etc…thank
Re: aeg lav86741 91400240500
Holding down Prewash and Stain buttons whilst turning programme knob to short spin should clear the fault however the cause is likely to be either a faulty solenoid on one of the water valves or a dirty/oxidised edge connector on the main PCB. Remove the edge connectors giving them a light rub with some emery ( best to do this one at a time so you don’t get them mixed up ! The plugs going onto the PCB can be lightly cleaned using an old tooth brush dipped in a little meths
- You must be logged in to reply to this topic.