bosche w/m wae24162

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › bosche w/m wae24162

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • March 6, 2012 at 12:10 pm #68288
    hdltd
    Participant

    wae24162u/k/8
    the fault is that the time gets to 9 mins then jumps to 1 min and only partailly spins havereplacedworn brushes but still doing fault any sugestions
    please
    John

    March 6, 2012 at 12:19 pm #370466
    electrofix
    Moderator

    Re: bosche w/m wae24162

    its not uncommon for slight earth faults on the heater to cause problems like this have you checked it

    will it do a spin only or will it do the same thing ?

    Dave

    March 6, 2012 at 9:13 pm #370467
    hdltd
    Participant

    Re: bosche w/m wae24162

    yeh it does thesame on spin only prog will check heater thanks
    John

    March 7, 2012 at 1:09 am #370468
    leavemetogetonwithit
    Participant

    Re: bosche w/m wae24162

    Brushes sometimes need a few washes to bed in on these. The thing somehow detects poor brush contact and shortens / aborts the spin to avoid motor damage. I read it on here somewhere after it happened on the first one I did.
    Mike.

    March 7, 2012 at 3:54 pm #370469
    hdltd
    Participant

    Re: bosche w/m wae24162

    it tumbles the way through the wash but seems to miss spin and jumps time down from 9 mins to 1 min and stops without spinning empties o/k nail biteing

    March 7, 2012 at 4:06 pm #370470
    leavemetogetonwithit
    Participant

    Re: bosche w/m wae24162

    Either tell cust to put it through an empty spin prog. half a dozen times and see if situation thereafter improves or go back, remove motor, and clean comm if not yet done, and give brushes a helping hand bedding in.
    Mike.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.