1607w E10 fault

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › 1607w E10 fault

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • March 9, 2012 at 9:57 am #68345
    nospin
    Participant

    Set the machine on a wash, doesn’t fill, pump runs continuous and then flashes e10. In manual it says flood switch activated which this hasn’t got or check for leaks. Definately not leaking. Pump just runs?

    March 9, 2012 at 10:02 am #370679
    kwatt
    Keymaster

    Re: 1607w E10 fault

    Could be something blocking the pressure sensor hose.

    K.

    March 9, 2012 at 11:59 am #370680
    nospin
    Participant

    Re: 1607w E10 fault

    Already checked that. Took it off and had a good look. Blew into pressure switch,chamber clear, that seemed fine?

    March 9, 2012 at 12:04 pm #370681
    kwatt
    Keymaster

    Re: 1607w E10 fault

    Best guess would be the level sensor then.

    K.

    March 9, 2012 at 12:19 pm #370682
    nospin
    Participant

    Re: 1607w E10 fault

    On this model its just a normal pressure switch unlike the 1606x which has a sensor? Just wondering if a valve is braking down under supply and causing pump to come on?

    March 9, 2012 at 12:23 pm #370683
    kwatt
    Keymaster

    Re: 1607w E10 fault

    First question: Have you run the diagnostics?

    That will tell you if there is a fault there.

    K.

    March 9, 2012 at 8:04 pm #370684
    Lawrence
    Participant

    Re: 1607w E10 fault

    Check where the block from the pressure switch goes on to the PCB .

    June 16, 2012 at 4:16 pm #370685
    nospin
    Participant

    Re: 1607w E10 fault

    Conclusion. Stacking ISE dryer had leaked onto washing machine and blew control pcb.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.