ISE 2

Home › Forums › Manufacturer/WP/Insurer Specific Forums › ISE Trade Support Forum › ISE 2

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • March 14, 2012 at 6:57 pm #68435
    johnmac11
    Participant

    Hi All,

    I have an ISE 2 vestel made machine that when you select any program it fills then gives a 5 second burst of the motor at full speed then no motor action. When you select spin it goes at full tilt for a few seconds then nothing.
    Appliance looks new inside with no signs of a damaged harness and insulation readings are perfect but I cannot get the machine into a test program.

    Is this a known board fault??

    John

    March 14, 2012 at 7:06 pm #371097
    Martin114
    Participant

    Re: ISE 2

    I have had a couple of ISE2’s do the same and each time it was a board fault.
    Martin.

    May 22, 2012 at 10:09 pm #371098
    steveDAS
    Participant

    Re: ISE 2

    Have you checked the Tacho on motor or leads to it

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.