- This topic has 8 replies, 4 voices, and was last updated 14 years ago by
.
-
Posts
-
Model M6006, sno, 20070617860, prod no, 010077204-01.
been to this call today, told me no power to m/c, wont start, and power light does not come on. checked appliance, and traced 240v through on/off switch. down to door switch (does not lock) so tried new door switch, but still the same, checked live to pcb,ok and live next to it goes to door switch, is it the main PCB?. stip out board cannot see any dry, or blown joints, any idea’s, totaly lost on this one gents.
Thanks
TELL..Re: its a servis washer fault, dead.
Is this a Janus type machine. (On the machines sticker you will see a code like 01 12 11 02 04 11.)
If it is then R1 resisitor on the board goes open circuit. Just link wire it out.
If its not a Janus type then the main board is the culprit.Re: its a servis washer fault, dead.
Hi
M6006 is a Vestel made machine
To activate autotest. Select 40 delicate and switch the machine on holding the prewash button at the same time, all light/buttons will be on . If the TH,pressure switch and door mechanism are OK ,the on/off light will start flashing,all the buttons light will go off and the automatic test will start.
Mike
Re: its a servis washer fault, dead.
Hi timdowning, is this not shown on the numbers I have giving you ? Above ie
010077204 01. Is that it?.
TELL..
PS. As for a test/diagnostic run, the washer will not power up, although 240v to on/off switch, and door switch but does not lock.Re: its a servis washer fault, dead.
HI
The machine is not a Janus type so will not have the numbers Tim gave.You need a new board and use test sequence that I gave you, to test machine when new board is fitted.
Mike
Re: its a servis washer fault, dead.
PS. Laptop died on sending thanks.
Thanks TIM for info aswell.
TELL..Re: its a servis washer fault, dead.
Would recommend you re-read simple pcb repairs thread. Particularly my last post there on page three.
Mike.
- You must be logged in to reply to this topic.