- This topic has 4 replies, 3 voices, and was last updated 13 years, 12 months ago by
.
-
Posts
-
hey all , this is a good un , customer removed rear cover to inspect and sayes it shows f06 fault , had a look over it, will pump out water and then stop after a few mins , found one wire off on the connector block at the motor, harness side , reconnected it but nothing i had a look at the board all seems fine there too brushes check out fine and tacho is showing continuity on and off when motor is turning power going to motor and tacho when in spin program , any clues guys thanks 😯
Re: whirlpool awo/d 5526 no spin
Is there a possible second wire that has broken but not snapped out of the motor block – or has the block on the pcb got a loose or damaged connection
Re: whirlpool awo/d 5526 no spin
i had a good tug at the wiring on the block next to the motor and i removed all the connectors on the board to check all seem fine
- You must be logged in to reply to this topic.