Smeg DWI614 E6 fault

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Smeg DWI614 E6 fault

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • April 11, 2012 at 10:31 am #68878
    OLLIE2806
    Participant

    Serial- 0514659503
    This built in dishwasher drains for a couple of minutes then throws up an E6 fault. It doesn’t fill at all, I can’t find any blockages, the pressure switch clicks over when I blow into it, have read it is a drainage fault but there is no water in there and drain pump seems fine.
    Any ideas?
    Thanks

    April 12, 2012 at 9:21 pm #373058
    clivejameson
    Participant

    Re: Smeg DWI614 E6 fault

    Worth a look at the dispenser solenoid, often go O/C or even intermittent. Try flexing the spades while you meter it to see if the circuit goes.

    A quick check is to connect any old good solenoid from a valve and see what happens 😉

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.