whirlpool adg 937 cycle change crash

Home › Forums › Public Support Forums › General Enquiries And Questions › whirlpool adg 937 cycle change crash

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 12, 2012 at 8:16 pm #68919
    bobvole
    Participant

    hello

    for a few month now we have been having and intermitant problem,The control panel freezes/crashes and its not posible to change cycles eg from rinse to 65deg. i have been to resolve this by turning of the machine and turning it on again whilst holding the cycle changeing button. this seamed to be the only way to fix it. any way that was a bit of a pain but no great stress.

    however this problem now occures nearly every time and now also there is water left in the bottom as if the cycle crashes before its finished.

    id love to try and fix this myself so would appriciate any advice!

    thanks

    Rob

    April 12, 2012 at 9:29 pm #373175
    MAG
    Participant

    Re: whirlpool adg 937 cycle change crash

    Hi Rob,

    From what you have said it sounds like you have an intermittent
    Pump fault or blockage, check the spout under the sink otherwise
    It could be a gradual earth leak.

    April 14, 2012 at 6:47 am #373176
    MAG
    Participant

    whirlpool adg 937 cycle change crash

    Also check broken wires in the door.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.