- This topic has 1 reply, 2 voices, and was last updated 13 years, 11 months ago by
.
-
Posts
-
Hi all,
I have a Hygena Dishwasher (AHY-8122), it has been working fine for the past four years, but today I turned it on and set it to the first wash cycle. I later returned 3 hours later to find the red power light still on, and the wash cycle still on first cycle! 👿 I then open the machine to find dirty plates and bone dry! It humms like in first cycle. I have check the water supply and it is ok. ❗ I may sound stupid, but is there a water pump inside of it, and do you think it may need changing? 💡
Any suggestions? ❓ ❓ ❓
Thanks for your time
Re: Hygena Dishwasher model ahy 8122 not fillinf with water.
try resetting the aqua lock on the fill valve by…turning off the water going to the dishwasher, screw off the hose at the dishwasher side, turn on the machine and set to a wash cycle, wait till you here the valve buzz which means its energized and open, wait a couple of mins with the power on which will allow the aqua stop to drain out the valve. turn power off. reconnect water hose, put dishwasher back on to a wash cycle , again wait till you you hear the valve buzz at which point gradually open the water supply tap to the dishwasher and you should hear it fill.
- You must be logged in to reply to this topic.