Zanussi ZDC37100W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZDC37100W

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 9, 2012 at 10:22 am #69383
    OLLIE2806
    Participant

    91609420805

    Hi guys the above tumble dryer runs for 15 odd mins then cuts out, and customer says it all seems very hot. All lights on the front light up. If she leaves it then manages to get it to start again it’ll run for a few more mind then stop again, the drum turns fine with a load in it. Air flow seems fine, could it be the pcb?

    May 9, 2012 at 12:22 pm #374606
    Martin
    Participant

    Re: Zanussi ZDC37100W

    Check the resistance (at room temp) of the NTC. It should read somewhere between 5.7 & 6.3 Kohm. 💡

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.