- This topic has 3 replies, 2 voices, and was last updated 13 years, 11 months ago by
.
-
Posts
-
How would you replace a drain pump on a Zanussi 1265w washing machine I am unable to remove the clips on the base. I just want to replace the pump only will spiting the case give me excess to the pump?
I managed to fit a new pump from underneath but only manage to get on screw in so i think its going to leak.
its also it displays error E90 nowRe: Zanussi 1265
Tilt appliance back insert a pair of pliers inbetween the grey “clips” on the underside then place a flat screwdriver under the pump and flick it to the left if you lie it right back be sure to protect the motor as some water will come out. The E90 error is a communication error between the two pcb’s and normally its the connection to the display pcb on the control panel that needs to be cleaned up
Re: Zanussi 1265
The clips hold the filter housing which the pump screws on too. so I should remove the filter housing with the pump? the pump is located at the back of the machine.
Could i jus take the rear off of excess to the pump?
- You must be logged in to reply to this topic.