- This topic has 7 replies, 4 voices, and was last updated 13 years, 11 months ago by
.
-
Posts
-
This machine aborts stright after start up …tested heater for earth leaks ..sent pcb to EMW (no fault found)
can anyone offer any advice. please JohnRe: Zanussi ZWF12070W
usually triac gone on board caused by inlet valve or interlock ,but as you have had board checked motor or wiring fault.whats coming up on diagnostics.
Re: Zanussi ZWF12070W
rocker wrote:not sure how to set up diagnostics. any advice please.
It’s the usual :
1. Switch off the appliance.
2. Press and hold down START/PAUSE button and the nearest option
button.
3. Holding down both buttons, switch the appliance on by turning the
programme selector by one position clockwise.
4. Continue to hold down the button till the LEDs begin to flash (at least 2
seconds).
In the first position, the operation of the buttons and the relative LEDs is
checked; turning the selector knob clockwise the diagnostics cycle for the
operation of the various components and the alarm reading is activated.The rotate dial to position 10 to read the error code. 😉
- You must be logged in to reply to this topic.