Beko WM7335W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Beko WM7335W

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 6, 2012 at 12:18 pm #69805
    Bryan
    Participant

    This washing machine will fill with water but motor momentarily bursts straight into fast spin rather than wash action.Set to spin water drains and again motor bursts into a short fast action and cuts off.

    Thought obvious motor fault but checked tacho and motor tests ok on megger, although access was somewhat limited.Can a faulty pcb cause this fault or am I missing something?
    Anyone familiar with this fault please?

    Thanks

    Bryan

    June 6, 2012 at 12:54 pm #376054
    electrofix
    Moderator

    Re: Beko WM7335W

    did you check tacho for continuity or output ?

    have you checked motor magnet has not snapped as this is not an uncommon fault

    Dave

    June 6, 2012 at 1:51 pm #376055
    Bryan
    Participant

    Re: Beko WM7335W

    Only checked tacho for continuity, in hindsight could well be a broken magnet as you suggest.
    Assume new motor required if magnet problem? doesn’t look like a screw on job as per the old Zanussi’s.

    Thanks for reply.

    Bryan

    June 7, 2012 at 9:00 am #376056
    electrofix
    Moderator

    Re: Beko WM7335W

    no probs m8

    yes new motor job although a few people on here have glued them with some success but in my opinion it does not constitute a reliable repair

    Dave

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.